monitor-by-isid

Create or modify a monitor based on the I-SID entry.

Syntax

default monitor-by-isid <1–1000> enable
monitor-by-isid <1–1000> egress-mlt <1–512>
monitor-by-isid <1–1000> egress-ports {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}
monitor-by-isid <1–1000> enable
monitor-by-isid <1–1000> map-to-vid <1–4093>
monitor-by-isid <1–1000> monitor-isid-offset <1-1000> {egress-mlt <1–512> egress-ports {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]} map-to-vid <1–4093>}
no monitor-by-isid <1–1000> egress-mlt
no monitor-by-isid <1–1000> egress-ports
no monitor-by-isid <1–1000> enable
no monitor-by-isid <1–1000> map-to-vid

Command Parameters

<1-1000>

Specifies the session ID.

egress-mlt <1-512>

Specifies the MLT to which the analyzers connect.

egress-ports {slot/port[/sub-port][-slot/port[/sub-port]][,...][slot/all][all]}

Specifies the port to which the analyzers connect.

Identifies the slot and port in one of the following formats:

a single slot and port (slot/port)
a range of slots and ports (slot/port-slot/port)
a series of slots and ports (slot/port,slot/port,slot/port)
all ports on the same slot (slot/all)
all ports on the switch (all)

If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

enable

Enables monitoring for the specific I-SID entry.

map-to-vid <1-4093>

Maps the mirrored packet to a specified VLAN ID for analysis. This parameter is optional.

Note

If you use the Extreme Integrated Application Hosting (IAH) port 1/s1 as the analyzer port on the monitoring BEB for remote mirroring, you must associate it to VLAN ID 4091.

monitor-isid-offset <1-1000>

Specifies the offset ID that is mapped to the actual monitor I-SID where packets are mirrored. Monitor I-SID = Base monitor I-SID + Offset ID. The base monitor I-SID is 16776000.

Default

None

Command Mode

Global Configuration